Anti Corrosive Epoxy Coatings

UGAM ANTICORROSIVE EPOXY COATING

These coatings used in marine weather or near high moisture area. These are mainly used to prevent the corrosion of metal and avoid the loss of the metal due to corrosion. The metal gets oxidized and looses its strength and property of supporting structure. This can be prevented with the help of suitable product. The product should be chosen after considering the main causes of the corrosion. If the corrosion is due to any other reason than moisture, then the chemical resistant coating should be used.

DESCRIPTION:

1) UGAM Anticorrosive EP product is used in outdoor areas of exposed steel.

2) UGAM Anticorrosive EP provides very good weather resistance for protection of steel.

3) Once used this does not need re application for about ten years.

4) UGAM Anticorrosive EP also is useful over concrete surfaces near water like bridges or in heavy rainfall areas. Bridges, flyovers are coated with UGAM Anticorrosive EP.

5) Multi-storey buildings are also coated with UGAM Anticorrosive EP.

6) UGAM Anticorrosive EP has excellent U V resistance, chemical resistance and temperature resistance up to 140 degrees C.

7) This can be applied to 100 microns thickness in one coat with airless spray or brush.

Application Procedure of UGAM ANTICORROSIVE EPOXY COATING:

1) UGAM ANTICORROSIVE EP is easy to use.

2) First prepare the surface with shot blasting in case of steel, high pressure water spray with minimum 300 bar pressure for concrete. In case high pressure machine is not available, wash with soap water and wire brush scrapping.

3) Apply UGAM PRIMER FOR EPOXY with brush, spray or roller. It is two pack system which need mixing of base with hardener in given ratio.

4) After mixing of base and hardener, UGAM THINNER FOR EPOXY needs to be added to achieve required viscosity as per application procedure.

5) Allow it to cure overnight.

6) Apply UGAM ANTICORROSIVE EP first coat with brush, spray or roller as required.

Since this is also two pack system, it also requires mixing of base with hardener in

Given ratio before application.

7) After mixing of base and hardener, UGAM THINNER FOR EPOXY needs to be added to achieve required viscosity as per application procedure.

8) Allow it to cure overnight.

9) Then apply second coat of UGAM ANTICORROSIVE EP by again mixing base+hardener+thinner as above.

10) The surface will be ready to use after 48 hours of final coating.

You can Email us on sales.ugamchem@gmail.com or contact us on +91-7219872619.

Feel free to get in touch for further queries, if any. 

The technical specification is correct to the best of our knowledge and under test conditions and we do not accept any liability towards misuse and contents of it. Product must be tested for specific use prior to use